- Second train video
- Semaphore test fixture
- First cut at servo bracket
Post by new members will not be visible until reviewed.
Posting spam is pointless.
Сообщение новых участников не будет отображаться до тех пор, пока оно не будет проверено.
Рассылать спам бессмысленно.
Posting spam is pointless.
Сообщение новых участников не будет отображаться до тех пор, пока оно не будет проверено.
Рассылать спам бессмысленно.
Phase II Raspberry Pi/Signals/Sensors/Simulator
Re: Phase II Documentation Updates
Say what you will about Sisyphus. He always has work.
Re: Phase II Documentation Updates
Say what you will about Sisyphus. He always has work.
Re: Phase II Documentation Updates
10 May '20
- Built another semaphore bracket and refined design
- Added a band saw to the machine shop
Say what you will about Sisyphus. He always has work.
Re: Phase II Documentation Updates
17 May '20
- New "Tools" section to the Hardware documentation for tools, jigs and modifications
- Made jigs to manufactures the servo arms to control the semaphore signals.
- Lots of issues with the jigs and the servo brackets.
Say what you will about Sisyphus. He always has work.
Re: Phase II Documentation Updates
Say what you will about Sisyphus. He always has work.
Re: Phase II Documentation Updates
31 May '20
- Added new LED shop lights
- Added DRO to the mill x-axis
- Having issues with a a page this week. Documentation page Mill X DRO
Say what you will about Sisyphus. He always has work.
Re: Phase II Documentation Updates
7 June '20
- Needed to clean the spindle RPM sensor.
- Moved the mill to make room for the lathe.
- Got the lathe stand in place.
Say what you will about Sisyphus. He always has work.
Re: Phase II Documentation Updates
14 June '20
- Mini Lathe upstairs, installed and setup started.
- Horizontal band saw assembled and tested.
Say what you will about Sisyphus. He always has work.
Re: Phase II Documentation Updates
28 Jun '20
- Dialing in the lathe
- Added a mod for the mill to the list
- More dual-headed semaphores to be shipped.
- Cleaned-up some spam on the bulletin board.
Say what you will about Sisyphus. He always has work.
Re: Phase II Documentation Updates
5 July '20
- First project for the lathe is a mod for the mill.
- More bits-and-pieces ordered.
Say what you will about Sisyphus. He always has work.